When traveling on a fork lift the carried load must be at the?
When traveling with a load, always make sure to tilt the mast of the forklift backward so that the load will firmly place against the backrest to make it more secure during transport. By doing this, you move the center of gravity towards to rear of the forklift making it more secure when traveling. Distribute the weight of the load properly.
Fasten your seat belt. Make sure the load is within the forklift’s rated capacity. The nameplate on the forklift lists its maximum load weight. Never exceed it! Use the proper lift fixture for the type of load, such as a carpet spike or drum grappler. Make sure the load is stable and centered; stack or tie uneven or loose loads.
Place the heaviest load near the truck’s front wheels. Never overload, see the forklift’s load capacity in the data plate. Travel in reverse if the load that you are carrying blocks the front view. Don’t look at just the mirror when reversing, rotate your head and look to the path where the forklift will be going.
When traveling on a fork lift, the carried load must be at the highest feasible position during travel False Safe lifting training should include: All of the above General requirements do not apply to slings used in conjunction with other material handling equipment for the movement of material by hoisting
Per CVC Section 35411, the load upon any combination of vehicles shall not exceed 75 feet measured from the front extremity of the front vehicle or load to the rear extremity of the last vehicle or load.
Place heavier loads on lower or middle shelves. Store long, tall or top-heavy items on their side or secure them to prevent tipover. Place ladders on stable, level surfaces, and use stair platforms to access materials in higher locations. Lift materials properly.
The outrigger must be placed on timbers or cribbed so as to spread the weight of the crane and the load over a large enough area. This helps to ensure that the crane remains stable and does not tip while in operation. Operators must ensure that hoisting chains and ropes are properly attached in reference to the load.
When using industrial forklifts the load must be at the lowest position for traveling and the truck? Lower the load so that its lowest point is 15 to 20 cm (6 to 8 inches) from the floor. While traveling, keep the load at a safe travel height.
When traveling on a fork lift, the carried load must be at the highest feasible position during travel. A wire rope sling with a strength of 10000 pounds and a total working load of 2000 pounds has a design factor (multiplier) of ________ .
