Hyster H60FT has a fault code 523920-3. I did not see it on the table. Any help is greatly appreciated. Forklift Plus November 16, 2020 at 2:28 PM – Reply. Hi,
The diagnostic code information that follows is utilized by Caterpillar machines that are equipped with Caterpillar electronic controls. Component identifiers, failure mode identifiers, and module identifiers are pieces of information that assist service personnel in diagnosing system problems of the machine.
DTC E30 is an ECCS C/U Error signal Most common result is failed relay. No supplied power to the ECM for some predetermined amount of time. ECM detects insufficient power supply.
Polyglandular dysfunction. NON-BILLABLE.
To reset this reminder, simply access the service maintenance interval screen by pressing the button directly below the gear icon. Using the buttons below the up and down arrows, highlight the compartment that was serviced and hit the reset button. This will turn off your reminder light until service is needed again.
E31 Electronic control throttle control error signal. E32 Overhear signal (STEP 1) E33 Overheat signal (STEP 2) E34 Spark system error signal. E35 LPG F/INJ disconnection diagnostic result signal.
What does E 32 mean on a CAT forklift?
